T-Lam 130-1

EPOXY TOOLING LAMINATING SYSTEM

  • Thermally stable up to 130°C / 265°F when fully post-cured
  • Low viscosity for wet-out of heavy weight reinforcements
  • Good Health and Safety
  • Low exotherm and extended pot-life makes this product ideal for large or complex moulds
  • Ambient curing and low shrinkage for accurate mould manufacture

T-Lam 130-1 Slow is an epoxy tooling system for manufacturing glass or carbon moulds by wet laminating. T-Lam 130-1 Slow is part of the 130°C / 265°F tooling systems and is compatible with the range of gelcoats, infusion, and repair materials.

T-Lam 130-1 Slow is a low shrinkage ambient curing system, which simplifies accurate mould manufacture. Designed for laminating and cure at 20°C / 70°F, it should then be mid-cured at 40°C / 105°F for 4 hours to guarantee the strength needed for demoulding. It can then be post-cured off the plug to give a material that is thermally stable to 130°C / 265°F.

Exceeding this temperature will cause a rapid loss in stiffness and a safety margin is required for the maximum tool operating temperature to prevent distortion or tool damage.

T-LAM 130-1 - 20 kg   

Resin

Article

20 Kg

T-LAM130-RC

Hardener

Typ

Article

8 Kg

Standard

T-LAM130-HC

 

Contact us

CTM GmbH - Composite Technologie & Material
Maria-Goeppert-Mayer Straße 2
24837 Schleswig - GERMANY
fon: +49 (0) 4621 95533
fax: +49 (0) 4621 95535
info@ctmat.de

Opening hours

You are welcome:

  • Monday-Thursday:
    8:00 am - 4:30 pm
  • Friday:
    8:00 am - 3:00 pm